Primer for deep penetration for concrete and brick surfaces
TERMION Grunt Facade - Liquid binder / Primer for old and new concrete and facade cement surfaces. Suitable for indoor and outdoor work.
Produced on the basis of acrylic emulsion for use as a general primer for all types of concrete / brick surfaces of roofs / walls / plinths to provide a high degree of waterproofing / increased adhesion to the substrate, for repair work and the creation of coatings with high binding properties. Designed for repair work (patching and coating with high plasticity).
TERMION Primer Facade - The binder is an aqueous solution that can be used for cement mixes. It is ideal for cement mortars and concrete. significantly increases waterproofing and bonding properties.
TERMION Grunt The facade has the following advantages:
1. HIGH WATER RESISTANCE
2. INCREASES THE STRENGTH OF THE SURFACE OF THE FOUNDATION
3. INCREASES ELASTICITY
4. INCREASES CLUTCH AND OPERATION LIFE
5. PROTECT FROM TERROR
6. DOES NOT CONTAIN SOLVENTS
Application area:
TERMION Grunt Facade designed for preparation
surface before the application of liquid thermal insulation series TERMION .
Substrate preparation:
The surface must be dry, clean and free from grease. Remains of loose coating, dirt and dust clean mechanically. For degreasing, rinse the surface with 3-5% soda solution, then rinse with water and dry. Glossy surfaces (old oil paint and enamel) shall be treated with a fine sandpaper to a roughness and cleaned from the formed dust. Cracks, potholes and irregularities zashpatlevat, then dry the surface to grind.
Instructions for use:
TERMION Ground Before use, the facade should be mixed well until smooth. Apply primer paint roller, brush or brush evenly over the entire surface, without the formation of puddles. Further finishing work can be done only after the primer has dried completely (after 12 hours after application, depending on drying conditions).
Technical information:
Appearance- White liquid
Degree of penetration- High
Viscosity - Medium
Toxicity - None
Application - Brush, roller or brush
Application temperature - +5 to + 35С
Consumption depending on the base - 100-200gr / m2
Drying time is 4 - 6 hours (depending on drying conditions)
Shelf life - 12 months
Attention! When working, observe individual security measures. In case of contact with skin or eyes, wash with plenty of water. Keep out of the reach of children.